为什么我用workbench将fluent得到的数据与模型进行耦合出现Mechanical Mapped Forces for Mechanical Surface 和CFD Computed Forces from CFD Results的力完全不一样,而且方向还是不同的,请教大家!CFD Computed Forces from CFD Results File C:UserscindyAppDataLocalTempWB_CINDY-PC_4588_2unsaved_project_filesdp0SYSMECHSolution 1zz-zjm-1357bu-2-00071.dat.gz X-component = 155.28 N Y-component = 34.769 N Z-component = -182.87 NMechanical Mapped Forces for Mechanical Surface File C:UserscindyAppDataLocalTempWB_CINDY-PC_4588_2unsaved_project_filesdp0SYSMECHImport_ANSYS_386.cdb X-component = -1026.2 N Y-component = -1006.2 N Z-component = -319.27 N16% of Mechanical nodes were mapped to the CFD surface, remaining nodes mapped to closest edge or node. 为什么会出现这种情况 |
|
|
|
|
共 0 个关于本帖的回复 最后回复于 2014-6-3 09:26